However I don't know if that matters for MainStage. I haven't found the channel setting to be an issue in Logic, they all (FCB Switches & Pedals) transmit on channel 1.
Have you tried to set the FCB up with MainStage's own Pedal Board? Maybe the issue is with your guitar rig? Is each swithch set to transmit a different programme change and is each stomp box set to receive the correct one? A bit basic I know but I wish that I could say that I never overlooked something as simple as that.ģ. are you using the latest version of iFCB? - 2.5.6Ģ. After countless YouTube videos watched and countless Google searches I managed to get it working as expected with Amplitube 4 in Logic.
I don't use MainStage but I use an FCB1010 and Wabbitwanch's iFCB. What I do notice is that when I assign the switches, on all of them the channel area comes up as "channel 1-16." Type is always coming up as "single value" im guessing mainstage reading all of them as channel 1-16 is the problem? Unless it's something else I'm missing here. I want each switch to control a different stomp box independently, NOT one switch controlling all. And all that's happening is that when I press switch 1, its turning both stomp boxes on, when I press switch 2, its also turning both stomp boxes on. However, I proceeded to map the next switch(2) of my behringer to the next stomp box, went to edit mode to see if it worked. I was successful at mapping the first switch on my behringer and it was turning the stompbox on and off like I wanted it to. I want to be able to press a botton on my Behringer and see distortion come on, then press it again and have it come off.
Its a full guitar rig with stomp boxes and such. What I'm trying to do is use worship guitar essentials that I purchased from a fellow named Abel Mendoza. Ifcb is definitely picking up my behringer(green light at the bottom left). Maybe I've been going down the wrong path I've entered Preset numbers on footswitches 1 - 3 in each of the first 3 Banks (1 - 3).
Wabbitwanch's ifcb.Īfter countless YouTube videos watched, countless Google searches, I still cant get this to work. I desire to have FCB1010 send Patch Select messages to change patches within an active Set in MainStage. So I have a scarlett 2i4 audio interface, my fcb1010 connected to it.